THIS IS AN UNFORMATED REPOSITORY OF INFORMATION FOR USE IN FORUMS AND IS ON GOING WORK.

When time permits and as the data becomes more complete I will be formatting the page into someting more useful.

Code links to mux bridge modified for inserting multiple messages :

CanBus recording

can-bridge-firmware.c

can-bridge-firmware.h

mcp25xx.c

The micro controller in the OBC/PD

r5f35 microcontroller

This is the some IPDM detail not included in the manual click for higher res.

leaf ipdm

LEAF on Plywood

Nissan Leaf on Plywood

Leaf PDM B24

The single connector to the PDM. see diagram below.

pdm test  hookup

Test jig, white board shown in photo attached to fromt of charger OBC/PDM

Lead PDM setup 1

350 volts of NIMH batteries to simulate a load, just incase it actually came on. No luck yet.

leaf pdm setup 2

Can Capture from configuration above, completely stand alone,

leaf pdm can capture

EVCAN system circuit data sniffing : CANEV SYSTEM Feb 22-2020.xlsx

PDM charger outline diagram.

leaf obc pdm charger diagram

 

Here is a data sheet that I understand is the heat of the PDM.

r01ds0019ej_m16c5m.pdf

Latest data from leaf on plywood via a man in the middle device built from an Arduino Due and CnDue 2.2 shield from EVTV and Collin Kidders original code,

Man in Middle first test